CALL US: 888-785-7288, INTERNATIONAL: 415-682-8685, MON-FRI 9AM-4PM PST
0 item(s)
MS121RSBDF1920D1 12.1" 2000 nits Sunlight Readable

MS121RSBDF1920D1 12.1" 2000 nits Sunlight Readable

Your Price: $379.99
In Stock
PII:MS121NXGA(C4)
  • 2000 nits Sunlight Readable :wide viewing angle and faster response time

Choose Options

LCD Controller Kit
Brand new MS121RSBDF1920D1 comes with 90 days warranty.
This brand new MS121RSBDF1920D1 is a direct replacement for the LCD screens that listed below. Simply swap out your defective LCD screen with MS121RSBDF1920D1, you now have a sunlight readable Monitor. MS121RSBDF1920D1 is designed to be used on outdoor environment. With our proprietary LED upgrade kit installed, It is so bright that the contents on display visible under strong sunlight. It is easy to install! No technical skills require! Anyone can do it!
MS121RSBDF1920D1 has a much wider viewing angle and faster response time then your old LCD screen. MS121RSBDF1920D1 has the same interface connector, dimension and screw hole as the LCD screens that listed below. The only thing that you need to is connecting MS610UBUB LED driver to the existing inverter wire harness. Tech support is available by contact us during our normal business. Our tech will walk you through. However, you can also send us an email to tehcsupport@lcdparts.net (Please be sure to send us few images about your inverter)
Compatible with the following Manufacturers and Models:
Manufacture Size LCD Screen
Toshiba 12.1" LTD121C30S, LTD121C30U-A, LTD121C31S
Toshiba 12.1" LTD121C32S, LTD121C33S, LTD121C33U
Toshiba 12.1" LTD121C34S, LTD121C35S
MS121RSBDF1920D1 General Specifications:
Item Unit Specifications
Screen Size [inch] 12.1
Native Resolution 800 X 600
Active Area [mm] 246.0(H) X 184.5 (V)
Outline dimension [mm] 278.3(W) X 209.0(H) X 11.0(D)
Bolt Hole Dimension [mm] 138.0 X 185.8
Input Voltage VDD [Volt] 3.3V
Screen Wire Harness DF19-20P-1LVDS-121W
Electrical Interface LVDS(6-bit)
White Luminance [cd/m2] 2000
Contrast Ratio 1:2000
LED Connector BHSR-02VS-1X1
LED Driver MS610UB
Response time, Rising msec 10
Response time, Falling msec 15
Viewing Angle - Horizontal degree 120
Viewing Angle - Vertical degree 140
How to connect MS610UB LED driver to your exiting LED wire harness
Most of LED drivers have the following functions:
VIN(Supply Voltage), GND (Power ground), ENA (Enable or ON/Off) and ADJ (brightness adjustment)
MS610UB comes with a 6 pin pig tails wires connector, it is color coded: Red=VIN, Yellow=ENA, White=ADJ and Black=GND
However, in a rate cases, if there is no  ENA (Enable voltage),  the solution would be disable enable by shorting VN to ENA on CN1 connector on MS610UB. When VIN shorted to ENA, all you need to do is applying supply voltage to VIN and GND.