MS104RSBDF1920D1is a direct replacement for the LCD screens that listed below. Simply swap out your defective LCD screen with MS104RSBDF1920D1, you now have a sunlight readable Monitor. MS104RSBDF1920D1 is designed to be used on outdoor environment. With our proprietary LED upgrade kit installed, It is so bright that the contents on display visible under strong sunlight. It is easy to install! No technical skills require! Anyone can do it!
MS104RSBDF1920D1 has a much wider viewing angle and faster response time then your old LCD screen. MS104RSBDF1920D1 has the same interface connector, dimension and screw hole as the LCD screens that listed below. The only thing that you need to is connecting MS610UBUB LED driver to the existing inverter wire harness. Tech support is available by contact us during our normal business. Our tech will walk you through. However, you can also send us an email to
[email protected] (Please be sure to send us few images about your inverter)
MS104RSBDF1920D1 included the following items:
10.4" Refurbished (Like new condition)LCD Screen, upgraded to SB series LED kit, Resolution: 800X600
MS610UB LED Driver
6 pin pigtail connector
Compatible with the following Manufacturers and Models:
Manufacture |
Size |
LCD Screen |
AUO |
10.4" |
B104SN02-V0, G104SN02-V1, G104SN02-V2 |
AUO |
10.4" |
G104SN02-V2, G104SN05-V0, G104STN01.0 |
Chi Mei |
10.4" |
G104S1-L01 |
MS104RSBDF1920D1 General Specifications:
Item |
Unit |
Specifications |
Screen Size |
[inch] |
10.4 |
Native
Resolution |
|
800 X 600 |
Active Area |
[mm] |
211.2(H) X 158.4
(V) |
Outline
dimension |
[mm] |
243.0(W) X 184.0(H)
X 8.0(D) |
Bolt Hole
Dimension |
[mm] |
132.6 X 166.6 |
Input Voltage
VDD |
[Volt] |
3.3V |
Screen Wire
Harness |
|
DF19-20P-1LVDS-
121W |
Electrical
Interface |
|
LVDS (6-bit/8-bit) |
White Luminance |
[cd/m2] |
2000 |
Contrast Ratio |
|
1:2000 |
BackLight Connector
|
|
BHSR-02VS-1X1 |
Backlight LED Driver |
|
MS610UB |
Response time,
Rising |
msec |
10 |
Response time,
Falling |
msec |
20 |
Viewing Angle -
Horizontal |
degree |
80 |
Viewing Angle -
Vertical
|
degree |
80 |
How to connect MS610UB LED driver to your exiting LED wire harness
Most of LED drivers have the following functions:
VIN(Supply Voltage), GND (Power ground), ENA (Enable or ON/Off) and ADJ (brightness adjustment)
MS610UB comes with a 6 pin pig tails wires connector, it is color coded: Red=VIN, Yellow=ENA, White=ADJ and Black=GND
However, in a rate cases, if there is no ENA (Enable voltage), the solution would be disable enable by shorting VN to ENA on CN1 connector on MS610UB. When VIN shorted to ENA, all you need to do is applying supply voltage to VIN and GND.